What is the reason for the long pause time of the slider conversion of the CNC bending machine? What are the precautions for the tool when the bending machine is running?

1. The upper chamber of the cylinder inhales air, and the pressure builds up for a long time.

2. The flow rate of the filling valve or the self-priming pipeline is small, or the sliding speed is too fast to cause vacuum suction.

3. The filling valve is not completely closed, and the pressure in the upper chamber decreases slowly.

4. After the valve is powered down, close the filling valve, and the upper chamber cannot absorb oil.

5. The wrong center position of the proportional valve leads to different openings and out of sync.

6. Is there any pause in the test to reduce the speed of the fast down?

7. The size of the fast down pressure has an influence on the closing of the filling valve, and the fast down pressure is excluded.

8. Adjustment of pressure parameters in the delay stage before work progress.

9. The damping hole of the control pipeline of the filling valve is too small, resulting in a pressure difference.

10. CNC system parameters, delay before slow down.

11. Numerical control system parameters, the gain parameter decreases slowly.